50
Parallel interface USP-PI
13
Moving an edge
It is necessary to move an edge, if the elevator cabin travels too
far or not far enough at a particular storey during creep travel.
Navigate to menu item ”Change shaft copy” on the
basis of the menu structure.
13
A move which would lead to
an overlapping of two signals
in the same trace will induce
an error message.
Esc
Back to ”level n” with
Select the level at which a move
is necessary.
Select the trace in which a move
is necessary.
Special case
Correction switch!
Only the value ”Lower edge”
should be changed with the
upper correction switch.
Only the value ”Upper edge”
should be changed with the
lower correction switch.
change
shaft copy
edge
moved
change
shaft copy
move edge
top edge
bottom edge
move to
top
move to
bottom
move by
0000 mm
edge
moved
trace
<Y>
1
trace
<Y>
15
level
1
level
45
Summary of Contents for USP-PI
Page 2: ...Seiten 3 30 Pages 31 58 Deutsch English...
Page 59: ......
