The following steps are required to remove the extension (1):
1.
Important:
Close the quick adjustment mechanism
up to the stop (see section “Setting the Clamping
Height, step 4”).
2. Turn the complete clamping disc counterclockwise.
While doing so, fix the piston rod (2) to the hexag-
onal mid section using a size 24 open-ended
wrench (SW24).
2
ð
The clamping disc with the screwed-on exten-
sion (1) is released.
3. Use a size 24 open-ended wrench to turn the ex-
tension (1) counterclockwise and remove it from
the clamping disc.
1
4. Screw the clamping disc clockwise onto the clamp.
5. Open the quick adjustment mechanism (see step 1
above).
6. For the next steps, see section “Setting the Clamp-
ing Height, steps 2–4”.
7 Start of Operations
7.1 Clamping the Workpiece
CAUTION
When the clamping disc is lowered, body parts may be present in the clamping range
Crushing of body parts
4
Ensure that the clamping height is set so that the distance between the clamping disc and the
workpiece is less than or equal to 6 mm.
4
Do not reach into the clamping range while the clamping disc is being vacuum-lowered.
EN-US · 30.30.01.03049 · 00 · 10/21
13 / 15
