OPERATOR'S MANUAL
6
Subject to technical changes
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
LuchsNT
Version: 27142-A.1
3
Connections and adjusters
3.1 Terminal
compartment
overview
The control unit has the following connections and adjusters marked on the printed
circuit board in the terminal compartment:
L, N and PE:
Mains input.
LED+, LED-:
Spotlights connection 24 V
1: "0..10V:
Standard signal input 0..10V with potentiometer power supply 10 V
2: DMX OUT:
DMX output for series operation
3: SYNC OUT:
Bus control unit synchronisation output
4: BUS:
Manchester bus interface
5: DMX PWR:
DMX 24V power supply for i-light
6: DMX IN:
DMX input for series operation
7: SYNC IN:
Control unit synchronisation input
8: LED:
RGB lighting "START/STOP" piezo button
9: START/STOP Sensor button input on/off
10: COLOR
Sensor button input colour selection
11: DIAG:
Button and 2 LEDs for diagnostic purposes
12: ADDR:
Manchester bus and DMX interfaces: Address setting
13: KONFIG:
Device configuration
Notice:
Rotary and dip switches 12 and 13 are read in once when the device is started.
A change of switch positions during operation is therefore not accepted until the next
device start.
Terminal compartment
disconnection
