35
EN
Troubleshooting / operation / maintenance / disassembly and disposal
6.4 Fitting the dial and cover plate - RTB
1.
Once the construction work is complete, remove the protective cap
from BEKOTEC-THERM-RTB.
2.
Set the sensor unit to position "3"
(Fig. 11 on page 28)
when attach-
ing the cover plate. This ensures that the dial and thermostat are in
the proper position. The sensor unit is pre-adjusted at the factory.
3.
Attach the cover plate with the integrated dial to BEKOTEC-
THERM-RTB.
Make sure that the wide tappet on the inside of the dial is located at
the top or in the marked position as shown in Fig. 21 on page 35.
i
7. Operation
Set the medium temperature of the surface heating circuit at the dial inside BEKOTEC-THERM-RTBR
(see 3.1.4.1 on page 25)
. Set the room tempera-
ture at the thermostat with remote adjustment
(see 3.1.4.2 on page 26)
.
Set the medium temperature of the surface heating circuit at the dial of BEKOTEC-THERM-RTB
(see 3.1.4.1 on page 25)
.
8. Maintenance
Regularly check the fittings and their connection points for leaks and functionality as part of system service.
9. Disassembly and disposal
9.1 Disposal
Caution
Risk of environmental contamination!
Improper disposal (e.g. with household garbage) can lead to environmental damage.
Dispose appropriately of packaging materials.
Dispose appropriately of building materials.
Dispose of the product unless there are return or disposal agreements.
If possible, components should be recycled.
Dispose of non-recyclable components in accordance with local regulations. Disposal in household waste is not permissible.
Fig. 21: Tappet on dial
Fig. 22: Attaching the cover plate with dial