36
Schleuniger CCM 1200
Maintenance
Cleaning, general
The CCM 1200 is very maintenance-friendly. Because the material is only cut and not stripped
virtually no dirt and dust etc. is produced. The best way to clean the casing is to use a damp cloth
and a standard general purpose cleaner. Do not use any corrosive solvents.
Cleaning the cutting zone
Switch the master switch off. Remove the mains plug from the power supply. The
following work should only be carried out by specially trained personnel (Schleuniger
representatives, the user’s trained specialist personnel).
•
Remove the cover together with the ejection shaft (Figure 12, Page 37).
•
Clean the cutting zone (Figure 15, Page 39) using a paintbrush and a vacuum cleaner
attachment.
Do not use any compressed air otherwise cable residues and dirt may be blown directly
into the electronics in the CCM 1200.
•
Fit the cover and insert the mains plug into the power supply.
A cleaning interval of 6 months is normally sufficient.
