4
/
33
1. General Information
1.1. Short Description
The system FS Uno is a one-support substructure for the mounting of photovoltaic modules in ground mount plants. The
supporting structure and the module-bearing rails are made of hot-dip galvanized steel, the fastening elements and screws/
bolts are made of steel or stainless steel. By means of the leveling holes, it is possible to adjust the system to the result of the
pile-driving process and even out tolerances. FS Uno allows to use framed as well as unframed modules that can be mounted
either in portrait or in landscape, or with the Schletter combined clamping system. It is also possible to mount additional
accessories for the cable management or components for the internal potential equalization.
1.2. Intended Use
FS Uno is a substructure for the mounting of photovoltaic modules. Any kind of different use that is not mentioned in these
Mounting Instructions or an incorrect mounting (e.g. the utilization of components made by other producers or non-
observance of tolerances specified here and/or exceeding the indicated loads) are considered as non-intended use and, thus,
exclude any liability of the manufacturer.
The manufacturer accepts no liability for damage caused by failure to observe these Mounting Instructions.
1.3. Copyright and Intellectual Property Rights
The entire content of these Mounting Instructions is the intellectual property of Schletter GmbH and is subject to the German
copyright law.
Any reproduction, editing, distribution, transfer to third parties - in whole or in part - and any kind of utilization beyond the
limits of the copyright law must be approved in writing by Schletter GmbH.
Schletter reserves the right to take legal action in case of infringements.
These Mounting Instructions are subject to change without notice.
All names of products stated in these Mounting Instructions are trademarks of Schletter GmbH and are herewith recognized
and acknowledged.
Schletter GmbH is not liable for any damage of the product or subsequential damage caused by the product that are due to
improper handling.
First and foremost, Schletter GmbH is not responsible or liable for failures and faults that are caused by modifications made
by the customer or other persons.
There is no claim for availability of previous designs and for the ability to retrofit delivered components to the respective
latest state of the series.
Schletter
Solar
GmbH has made considerable efforts to make sure that these Mounting Instructions are
free of errors and omissions.
Schletter
Solar
GmbH does not assume any responsibility or liability for possible errors included in these
Mounting Instructions and/or incidental, concrete or consequential damages arising from the
publication of these Mounting Instructions.
Mounting instruction
FS UNO
with SRF Foundation Posts
| 2016.09 V.0
04
Schletter Solar GmbH – Alustraße 1 – 83527 Kirchdorf
