The cord is fitted by default.
See below when reinstalling.
Disassemble the back and
attach it to the connection
area.
Remove adhesive protection and
attach the steel pad to the side
of the product.
Remove Thumb-turn from the
product.
Installation Considerations
• Glass door gap : 2.5mm~5mm
• 2-door glass door upper and
lower deviation : within 2.5mm
2-door glass door before and
after deviation : within 2.5mm
• If doors are severely slanted,
horizontal glass door and
before/after should be
within 2mm.
• If the gap of glass door is
bent out of shape, automatic
locking may be difficult or fail.
(Proceed with caution)
1
2
3
Thumb-turn
Steel pad
Dead bolt for safety glass doors
For details regarding
product and installing
method, please refer
to the website.
※ It is recommended to install
without the safety glass rubber.
RH Single
1
2
Right door handing shown.
Left/Right direction changing method
RH Double (w/S-260H)
LH Single
1
2
LH Double (w/S-260H)
Remove thumb-turn and attach it
to steel pad when going out,
and open and close the door to
activate the outing mode .
How to install thumbturn cord
How to install a steel pad
Australia
Phone: 1800 098 094
Email: [email protected]
www.allegion.com.au
South East Asia
Phone: +65 6488 2562
Email: [email protected]
www.allegion.com
New Zealand
Phone 0800 477 869
Email [email protected]
www.allegion.co.nz
Middle East, India & Africa
Phone +971 4 818 8999
Email [email protected]
www.allegion.com/mea