20 • Schlage • CT5000 user guide
Manual programming error codes
L
Error codes are indicated at the reader by a blinking red LED. The number of red
blinks indicates the error code.
L
The CT5000 may not provide complete control of the reader’s beeper or LEDs.
Please consult the reader’s manufacturer for instruction on reader configuration.
Number of
red blinks
Error code description
1
Computer programming error (not complete).
2
Too long user/master code entered. Master code length must be five (5) digits.
User code length cannot exceed 6 digits.
3
Memory full, too many codes. Delete some codes.
4
Master code cannot be deleted, only changed.
5
Master code entries do not match. Master code not changed.
6
Invalid command. Invalid function code entered.
7
Code not found.
8
Code too short. Master code length must be five (5) digits. User code
minimum length is three (3) digits.
9
Not a unique code.
10
Manual programming not allowed.
Using the CT5000 controller
After credentials have been programmed, present credentials to operate the CT5000 controller
as follows:
Credential
type
Action
Credential Present credential to reader
Green blink and access granted
+ PIN
Credential
Present credential to reader
Press PIN
1
Green blink and access granted
1 The default PIN length is six digits. The “#” key must be used as an ENTER key for PINs with fewer than six
digits. PIN length can be manually configured (refer to
Change PIN Length
on page 19).
Reader LED reference
The CT5000 supports independent reader LED and beeper operation. The credential reader
being used may or may not allow independent control of the reader’s LEDs. Please consult
the credential reader’s manufacturer for instruction on reader configuration.
The table below represents the operation of most available credential readers. LED feedback
during manual programming may differ depending on the reader configuration used.
Reader condition
Reader LED
Access denied
2 red blinks
Access denied, user outside time zone 4 red blinks
Factory default reset
No LED indicator while clearing memory, then a one -
second solid green and one beep when complete
Waiting for PIN (Card + PIN)
5 alternating red and green blinks
Low battery indicator, coin cell battery 1 green and 3 red blinks before valid access
Momentary unsecured access
Solid green while unlocked
