Schiller LITTLE WONDER monster 8495-06-01, Parts And Operator'S Manual

Page: 8 / 27

6
TRUCKLOADER
SAFETY
BATTERY
WARNING
Battery acid is caustic , fumes are explosive and can
cause serious injury or death.
- When working with battery acid, use protective
equipment such as, but not limited to, goggles,
face shield, rubber gloves and apron.
- Avoid leaning over a battery.
- Do not expose a battery to open flames or sparks.
- Fill batteries with filler caps properly with fluid.
- Do not allow battery acid to contact eyes or skin.
Flush any contacted area with water immediately
and get medical help.
- Charge batteries in an open, well
-
ventilated area,
away from sparks and flames. Unplug charger
before connecting or disconnecting from battery.
ENGINE
- Read and understand the engine manufacturer's
operation manual.
- Don't run engine if there is an accumulation of
debris around the muffler and cooling fins.
- Don't run engine while electrical system causes
spark outside the cylinder.
- Don't touch hot mufflers, cylinders or cooling fins
or serious burns may occur .
OIL
- EQUIPMENT IS SHIPPED WITHOUT OIL! Refer
to engine manufacturer ' s operation manual for
instructions on filling the oil.
STORAGE AND TRANSPORTATION
- Stop the engine and allow to cool before storing.
- Drain the fuel tank outdoors only.
- Store fuel in an approved container in a cool, dry
place.
- Keep the machine and fuel containers in a locked
storage place to prevent tampering and to keep
children from playing with them.
- Do not store the machine or fuel container near
heating appliances with an open flame such as a
water heater or an appliance with a pilot light.
- Keep gasoline storage area free of grass, leaves
and excessive grease to reduce fire hazard.
- Clean grass and debris from cutting units, drives,
mufflers and engine to help prevent fires.
-
S
tore indoors in a sheltered area (a dry place)
where it is not accessible to children. DO NOT
store in a house.
JUMP STARTING
1. Be sure the jumper cables are in good condition.
Turn off the ignition and all electrical accessories
on both machines.
2. Position the machine with a good (charged) bat-
tery next to but not touching the machine with the
dead battery so jumper cables will reach.
3. When making cable connections:
- make sure the clamps do not touch anywhere
except to intended metal parts,
- Never connect a positive ("+" or red) terminal
to a negative ("–" or black) terminal.
- Make sure the cables won't get caught in any
parts after the engines are started.
4.
Connect one end of the first jumper cable to the
positive terminal on one battery. Connect the
other end to the positive terminal on the other
battery.
5. Connect one end of the other cable to the
negative terminal of the machine with a good
(charged) battery. Make the final connection on
the engine of the machine to be started, away
from the battery.
6.
Start the vehicle with the good battery, then the
machine with the discharged battery.
7.
Remove the cables in the exact reverse order of
installation. When removing each clamp, take
care it does not touch any other metal parts while
the other end remains attached.