30
QUICKCAT
MOWERS
®
ADJUSTMENTS
HYDROSTAT TRANSAXLE
A turnbuckle-style hydrostat neutral adjustment is
provided.
Neutral adjustment is for setting the location of the
control handles with respect to each other or the
operator presence slot, or parking brake locks.
Neutral:
(neutral is set by the hydrostatic transaxles)
1. Loosen jam nuts A at both ends of the control rod
B.
2. Loosen the nuts C on the control lock rod D.
3. Rotate the control rod B until both left and right
handle is aligned with the slot of the control
panel.
4. Tighten the jam nuts A at the top and the bottom
of the control rod B.
5. Press the control lock rod D into the slot in the
control and tighten nut C. See
FIGURE 2
To check:
1. Start the engine and run at 1/2 throttle.
2. With the LH control handle in the NEUTRAL po-
sition rotated up, move the parking brake lever
to PARK and turn the PTO (Blades) ON. Each
check should kill the engine after 1/2 second de-
lay. ( A 1/2 second delay is built inot the system
to prevent engine cut-out when traversing rough
terrain.)
Repair machine before using if the Operator Pres-
ence Interlock System does not operate correctly
in start or run. Contact your authorized BOB-CAT
dealer.
FIGURE 1
FIGURE 2
