Grinding Tips:
1.
After you have set the angle, turn on the Wet Grinder and begin the grinding
process.
2.
Press the tool evenly onto the Grinding Stone (19) near the cutting edge, and
move the tool crosswise across the Stone. Make sure that at least half the width
of the cutting edge comes into contact with the Grinding Stone at any time to
avoid damage to the Stone.
3.
Allow the Grinding Stone (19) to do the cutting. Do not apply excessive down-
ward pressure on the tool when grinding.
4.
Make sure the level of water in the Water Tank (41) is adequate. Do not attempt
to dry grind.
5.
When finished, turn off the Wet Grinder. Wait until the machine has completely
stopped. Unplug the machine from its electrical outlet. Then, remove the tool.
Honing Tips:
1.
Never hone
against the direction of the rotating Honing Wheel (27). Otherwise,
the tool will cut into the leather Honing Wheel.
2.
Although you can work “free hand” for the honing process, you will achieve more
precise results by securing the tool with the Support Plate (16) or Holder (6) and
setting the honing angle to the angle used when grinding the tool.
3.
Press the tool evenly onto the Honing Wheel (27) near the cutting edge, and
move the tool crosswise across the Wheel. Make sure that at least half the width
of the cutting edge comes into contact with the Wheel at any time to avoid
damage to the Wheel.
4.
Allow the Honing Wheel (27) to do the honing. Do not apply excessive down-
ward pressure on the tool when honing.
5.
Always keep the Honing Wheel (27) saturated with machine oil and Abrasion
Paste (43) for optimum results.
6.
When finished, turn off the Wet Grinder. Wait until the machine has completely
stopped. Unplug the machine from its electrical outlet. Then, remove the tool.
PAGE 1
3
