www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
72 | GB
• Set the rotary table (14) to the desired angle (refer also to point 8.4 in
this regard).
• Fold the locking handle (11) downwards to secure the rotary table (14).
• Undo the set screw (22).
• Use the handle (1) to tilt the machine head (4) to the left until it coin-
cides with the required angle value (in this connection see also section
8.6).
• Re-tighten the set screw (22).
• Cut as described under section 8.3.
8.8 Limiting the cutting depth (fig. 3/13)
•
The cutting depth can be infinitely adjusted using the screw (24). To do
this loosen the knurled nut (24a) on the screw (24). Turn the screw (24)
in or out to set the required cutting depth. Then re-tighten the knurled
nut (24a) on the screw (24).
• Check the setting by completing a test cut.
8.9 Sawdust bag (fig. 1/22)
The saw is equipped with a debris bag (17) for sawdust and chips.
Squeeze together the metal ring on the dust bag and attach it to the
outlet opening in the motor area.
The debris bag (17) can be emptied by means of a zipper at the bottom.
8.9.1 Connection to an external dust extractor
• Connect the vacuum hose with the dust extraction spout.
• The industrial vacuum cleaner must be suitable for the material being
worked.
• When vacuuming dust that is especially detrimental to health or car-
cinogenic, use a special vacuum cleaner.
8.10 Changing the saw blade (fig. 1/2/14
−
17)
Remove the power plug!
Attention!
Wear safety gloves when changing the saw blade. Risk of injury!