www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
GB | 67
8. Attachment and operation
8.1 Attaching the sliding compound mitre saw (fig. 1/2/4/5/23)
• In order to adjust the rotary table (14), fold the locking handle (11) up-
wards and pull up the latched position lever (35) with your index finger.
• Turn the rotary table (14) and pointer (12) to the desired angle meas-
urement of the scale (13). To fix the setting, fold the locking handle (11)
downwards.
• Pressing the machine head (4) lightly downwards and removing the
locking bolt (23) from the motor bracket at the same time disengages
the saw from the lowest position.
• Swing the machine head (4) up.
• It is possible to secure the clamping devices (7) to the left or right on
the fixed saw table (15). Insert the clamping devices (7) in the holes on
the rear side of the stop rail (16) and secure it with the star grip screws
(7a).
For 0°- 45° mitre cuts, the clamping device (7) must only be mounted
on the right side (see fig. 11-12).
• It is possible to tilt the machine head (4) a max. 45° to the left by loos-
ening the set screw (22).
• Workpiece supports (8) must always be secured and used during
work. Set the desired table size by loosening the set screw (9). Then
tighten the set screw (9) again.
8.2 Precision adjustment of the stop for crosscut 90° (fig. 1/2/5/6)
• No stop angle included.
• Lower the machine head (4) and secure it using the locking bolt (23).
• Loosen the set screw (22).
• Position the angle stop (A) between the saw blade (6) and the rotary
table (14).
• Loosen the lock nut (26a).
• Adjust the adjusting screw (26) until the angle between the saw blade
(6) and rotary table (14) is 90°.
