english 17
Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially haz-
ardous substances that are often contained in electri-
cal and electronic equipment. By properly disposing
of this product, you are also contributing to the effec-
tive use of natural resources. You can obtain informa-
tion on collection points for waste equipment from
your municipal administration, public waste disposal
authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.
Trouble shooting
Problem
Possible Cause
Help
Motor doesn’t start
a) No electricity
b) Defective switch, condenser
c) Defective extension cord
a) Check fuse
b) Have an electrician inspect unit
c) Unplug cord, inspect and replace, if
necessary
Drilled holes become
larger than the drill bit
Headstock and tailstock are not parallel.
Set up headstock according to the tailstock
tip. Insert carrier into the drilling spindle for
this and position the tailstock with tip up to
a distance of approx. 1°mm.
Work piece flatters
while working
a) Working piece becomes loose while
working
b) Work piece is not properly centered
c) Rotational speed is too high
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Tool rest or tailstock
cannot be clamped
Setting the eccentric clamping
Return the hexagonal nut at the bottom
side about ½ rotation with the socket span-
ner
Summary of Contents for 1902301901
