Instruction Manual for Electroblock EBL 271
7
Date: 14.02.2011
811.523 BA / EN
Fault
Remedy
Possible cause
12V supply does not work
in the living area
12V main switch for the li-
ving area battery is swit
12V main switch for the li-
ving area battery must be
in the living area
ving area battery is swit-
ched off
ving area battery must be
switched on
Not all plugs or fuses are
plugged into the electro
Insert all plugs and fuses
(correct values) into the
plugged into the electro-
block
(correct values) into the
electroblock
Defective fuse or wiring
Check fuse and wiring
Defective fuse or wiring
Check fuse and wiring
Defective electroblock
Contact customer service
Marker lights do not work
Polyswitch fuse has trip-
ped
Switch off the electroblock
for at least 1 minute (di-
sconnect from 230V sup
sconnect from 230V sup-
ply if required), then switch
it on again
No control signal from the
basic vehicle
Check the base vehicle
Y
The charging current is reduced automatically if the device becomes too
hot due to excessive ambient temperature or lack of ventilation. Always
prevent the device from overheating nevertheless.
Y
If the automatic shutdown mechanism of the battery monitor is triggered,
fully charge the living area battery.
3.4 Closing down the system
A battery is isolated by switching off the main switch on the IT .../LT ... con-
trol and switch panel and by disconnecting a plug connector.
Y
ATTENTION!
Damage to the living area battery as a result of total discharge. So therefore:
F
Fully charge the living area battery before and after closing down the
system. (Connect vehicle to the mains with an 80Ah battery at least
12 hours and with a 160Ah battery at least 24 hours).
When the motorhome is not used for a long time, consumers with a perma-
nent supply should be disconnected from the battery.
"
12V supply on the IT ... / LT control and switch panel must be switched
off.
"
Fully charge the living area battery before closing down the system.
"
Remove the MNL connector on block 4 of the electroblock.
The living area battery now only supplies the permanent positive input of the
radio (e.g. to prevent the code from having to be re-entered every time after
closing down).
Follow the instructions of the battery manufacturer.
Closing down
