Instruction Manual for Electroblock EBL 271
3
Date: 14.02.2011
811.523 BA / EN
2 Introduction
This instruction manual contains important information for safe operation of
the device. Make sure you read and follow the safety instructions provided.
The instruction manual should always be kept in the vehicle. All safety infor-
mation must be passed on to other users.
3 Operation
The electroblock is operated solely via the IT ... / LT ... control and switch
panel connected. .
Operation of the EBL 271 electroblock is not required in daily use.
Settings only have to be configured once when the battery type is changed
(lead-acid or lead-gel), during initial start-up or when retrofitting accessories
(see Section 3.2 and the installation instructions for the EBL 271).
3.1 Starting up the system
Y
ATTENTION!
Incorrect electroblock settings can result in damage to connected devices.
Therefore prior to starting:
F
Ensure the living area battery is connected.
F
Ensure that the battery selector switch (Fig. 3, Pos. 9) is set to the
correct position for the battery installed.
Use the main 12V switch (see instruction manual for relevant control and
switch panel) to switch on/off all the consumers and the control and switch
panel.
Outputs are exceptions:
F
Car radio
F
Heater
F
Refrigerator controller
F
Step
F
Awning light
F
TV
These outputs are not disabled via the main switch of the IT ... /LT ... control
and display panel.
Please refer to the operating instructions for the IT ... /LT... control and
switch panel for further information. .
