Instruction Manual for Electroblock EBL 271
5
Date: 14.02.2011
811.523 BA / EN
1
Fig. 1
Battery selector switch
"
Move the battery selector switch (Fig. 1, Pos. 1) into the correct position:
F
Lead gel battery: Move the battery selector switch to ”Lead-gel”.
F
Lead acid battery: Move the battery selector switch to ”Lead-acid”.
F
AGM battery: Schaudt GmbH recommends charging AGM batteries
with their chargers in switch position ”Lead-gel battery”.
We believe that AGM batteries can be charged perfectly this way. Ho-
wever, suitability must be checked using information from the battery
supplier and the charging parameters of Schaudt equipment. The
charging parameters are specified in the operating and installation
instructions.
"
Start up the system as described in Section 3.1.
3.3 Faults
A fault in the power supply system is usually caused by a blown fuse.
Please contact our customer service department if you cannot rectify the
fault using the following table.
If this is not possible, e.g. if you are abroad, you can have the electroblock
repaired at a specialist workshop. In this case you must ensure that the war-
ranty is not invalidated by incorrect repairs being carried out and Schaudt
GmbH will not accept any liability for damage resulting from such repairs.
The following functions are protected by a polyswitch fuse:
F
12V indicator
F
Battery 1
F
Output D+
F
Marker lights
If there is a fault here, the cause of the overload must be rectified. After-
wards, the relevant supply circuit must be interrupted for a period of about 1
minute (e.g. by removing the relevant connector, see block diagram on Page
14). The polyswitch fuses are reset automatically during this period.
AGM batteries
Starting up
the system
Flat vehicle fuses
Polyswitch fuses
