Operating Instructions Caravan-charging system CSV 416
5
Date: 30.05.2021
8050111 BA / EN
3.2 Switching on and off
Control and switch panels must be supplied with a separate operating ma-
nual (kept with the vehicle). Please refer to this manual for instructions on
operation.
Activating the 12V main switch (12V ON) on the operating panel connected
enables/disables the following electrical circuits:
Pos. Circuit
Fuse with
1
Heater
10 A -- With the mains supply, there is no switch-off
by the main 12V switch
2
Pump/WC
10 A -- Can be enabled individually over the bus
3
Circuit 1
15 A -- Can be enabled individually over the bus
4
Circuit 2
15 A -- Can be enabled individually over the bus
5
Circuit 3
15 A
6
Awning light
10 A
7
TV
8
Spare
5
Circuit 4
15 A
5
Circuit 5
10 A
Outputs
F
switching output 1
F
switching output 2
F
switching output N
can only be enabled over the bus, regardless of whether the main 12V
switch (12V ON) is switched on or off.
3.3 Changing the battery
Y
ATTENTION!
The use of incorrect battery types or incorrectly designed batteries can
damage the battery itself or devices connected to the caravan charging
system. So therefore:
F
Batteries may only be changed by qualified personnel.
F
Follow the battery manufacturer’s instructions.
F
The caravan charging system is only suited for connecting to 12V
power supplies with chargeable batteries (of the types specified be-
low).
F
Do not use non-approved battery types such as NiMH batteries.
Y
Normally only batteries of the same type and capacity should be used,
i.e. the same as those installed by the manufacturer.
It is possible to swap from lead-acid batteries to other battery types.
Switching to lead-acid batteries is only possible in certain circumstances.
Contact the vehicle manufacturer for more information.
