Figure
18
Figure 19
3.3.2 Installation
of the
Motor
s
1)
Choose the correct mounting position of the motors.
2)
Check that the mounting surfaces for the brackets are level.
3)
Insert the cables for the power supply to the motors.
4)
Install the motor mounts as shown in Figure 18.
5) Remove the two screws on the engine and remove the cover as shown in Figure 19.
6) Move the gate leaves to the closed position.
7) Refer to the distance "B" as determined in Figure 17. Hold the rear plate of the bracket at the intended mounting
point. Check the distances as shown in Figure 23.
8) If the bracket is at the point where it should be mounted, then mark the four holes. Use an 8 mm drill for this
purpose. Now secure the bracket with screws and washers.
9) Make sure the bracket is completely level.
10) The distance between the rear pivot point and the frontal pivot point is 798 mm. The distance between the
lower edge of front intake to center frontal pivot attachment is 22.5 mm. See Figure 23.
11) Temporarily secure the front bracket to the gate with a clamp. See Figure 24.
139
Figure
20
Figure
21
Figure
22
43 mm
798 mm
22.5 mm
Figure
23
Figure
24
11
