– 2 –
– 3 –
CLOCKWISE SPINNING
■
Hook the spring on the Scotch ten-
sion spring bar on the left side of the
mother-of-all.
■
Place the string over the bobbin
pulley.
■
Insert the end of the string in the
hole in the Scotch tension rod on the
right side of the wheel.
■
Turn the Scotch tension rod to
loosen or tighten the string.
COUNTER-CLOCKWISE
SPINNING
■
Hook the spring loop on the Scotch
tension rod on the right side (figure
A).
INSTALL THE BULKY FRONT
MAIDEN
■
Insert the bulky front maiden so
that the maiden stop (black hex head
screw) is facing the rear of the wheel.
■
Line up the hole in the bulky front
maiden with the bolt and push it
through to the other side.
■
Place the two washers on the end of
the bolt and secure with the T-knob.
INSTALL THE BULKY FLYER
■
Loosen the front maiden so that it
can be tipped toward you as you sit in
front of the wheel.
■
Insert the orifice end of the flyer
into the front maiden bearing.
■
Drape the drive band over the flyer.
■
Insert the whorl end of the flyer in
the rear bearing.
■
Secure the front maiden.
■
Install the drive band. We recom-
mend doubling the drive cord over
the whorl for Scotch tension.
GETTING READY TO SPIN
We recommend using the Bulky Flyer
Plyer Head in Scotch tension mode.
To set your wheel up for Scotch ten-
sion, install the Scotch tension spring
and string.
front
maiden
flyer
scotch
tension
spring
bar
scotch
tension
spring
scotch
tension
string
FIGURE A - RIGHT SIDE
