– 2 –
– 3 –
FOR WHEELS BUILT BEFORE 1/19/12
REMOVE THE FRONT MAIDEN
■
Remove the flyer, bobbin and
whorl.
■
Unscrew the T-knob and remove it
and the two washers.
■
Using a hammer and a block of
scrap wood, gently tap out the bolt.
■
Pull on the bolt until the front
maiden is released. Do not remove
the bolt from the mother-of-all.
(Note: on older Matchless wheels,
there is an insert with the T-knob bolt.
Remove the bolt; the insert stays in
place.)
■
Remove the front maiden.
CONTENTS
■
Bulky front maiden & bearing
■
Bulky flyer
■
Bulky bobbin
■
5mm hex wrench
T-knob
hammer
scrap wood
bolt
FLYER WITH BOBBIN AND FRONT MAIDEN
adjustable
flyer hook
stationary
flyer hook
orifice
bearing
flyer shaft
shoulder
5mm hex
wrench
This manual is divided into three
sections: one for wheels built
before 1/19/12, one for wheels
built after 1/19/12, and one
that contains information per-
tinent to all wheels. Check your
wheel’s serial number (stamped
into the wood on the rear of
the mother-of-all) to determine
when your wheel was built.
