– 4 –
– 5 –
rear bar
scotch tension
peg
quick release
lever
straight
end
loop end
front
bar
hole in
shaft
straight
end
INSTALL THE BULKY FLYER
■
Loosen the front maiden so that it
can be tipped toward you as you sit in
front of the wheel.
front
maiden
flyer
■
Insert the orifice end of the flyer
into the front maiden bearing.
■
Drape the drive band over the flyer.
■
Insert the whorl end of the flyer in
the rear bearing.
■
Secure the front maiden.
■
Install the drive band. We recom-
mend doubling the drive cord over
the whorl for Scotch tension.
SCOTCH TENSION MODE
We recommend using the Bulky Flyer
Plyer Head in Scotch tension mode.
Install the Scotch tension spring and
cord as follows:
■
Slide the loop end of the Scotch ten-
sion brake spring and cord under the
rear bar, laying the loop to one side.
You can use your threading hook to
pull the loop up if needed.
■
Adjust the Scotch tension peg so
that the hole in the shaft is visible.
Take the straight end of the cord over
the front bar and into the hole.
■
Install the flyer, with the large end
of the bobbin toward the back of the
wheel.
■
Place the loop over the large end of
the bobbin, and the drive band over
the whorl. The drive band should be
taut but not overly tight.
■
Turn the Scotch tension peg to take
up the slack in the cord, allowing the
cord to wind around the shaft of the
peg.
■
If the cord slips and won’t wind up,
you can make a double knot about
1" from the end of the knot. We don’t
recommend cutting the cord.
