Scarlett SC-SI30K39, Instruction Manual

Page: 5 / 27

IM020
www.scarlett.ru SC-SI30K39 5
LABEL TYPE OF TEXTILE
Do not iron this article
•
Synthetics, Nylon, Acrylics, Polyester, Rayon
••
Wool, Silk
•••
Cotton, Linen
Maximum temperature (Steam)

Place the iron on the base and slide the lock into position « »

Insert the mains plug into the wall socket. The indicator light will turn on.

When the indicator light goes out you may start ironing.
WORK

To use the iron in wireless mode, move the iron clip on the base to the " " position.

The time of using the iron in wireless mode reaches: 2 minutes in the dry ironing mode, 40 seconds in steaming
mode. The recharging time is 10 seconds.

The iron can also be used to perform basic functions together with the base. To do this, fix the iron on the base in
the " " position.
SPRAYING

As long as there is enough water in the water tank, you may use the spray button at any temperature setting
during steam or dry ironing.

Press the spray button several times to activate the pump while you are ironing.
STEAM IRONING

With the unit unplugged, fill the steam iron with water.

Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug in.

Set the temperature control di
al to the “••“ or “•••” position.

CAUTION: Avoid coming in contact with ejected steam.
DRY IRONING

The steam iron can be used on the dry setting with or without water in the water tank, however it is best to avoid
having the water tank full while dry ironing.

Turn the variable steam control to the minimum position .

CAUTION: If the steam iron has been used for a long time, it is hot and there is no water. Do not refill it with
water until the steam iron cools down.
BURST OF STEAM

The burst of steam feature provides additional steam for removing stubborn wrinkles.

Press the powerful steam button to release the burst of steam.

NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button pressed for more
than 5 seconds.

NOTE: For the best steam quality, do not use more than three successive bursts each time, because the iron will
cool.
VERTICAL STEAM

Ensure that there is enough water in the water tank.

Stand the steam iron on its heel rest on an iron-safe surface and plug it.

Set the temperature control dial and variable steam control to their maximum positions.

Hold the iron vertically and press the steam burst button, an intense steam will be ejected from the soleplate.
ANTI-DRIP FUNCTION

The ‘Anti-drop’ function prevents water spills and helps avoid the blotches on the fabric which may appear when
the iron works at low temperatures.
ANTI-CALC FUNCTION

Your steam iron has anti-calc function that protects your appliance from scale.
WHEN YOU FINISHED IRONING

Set the temperature dial to the minimum position.

Remove the mains plug from the wall socket.

At the end of the work, always completely remove the water from the tank.

After draining the water from the cooled iron, place it vertically on the base and turn on for 2 minutes in maximum
heating mode, then disconnect the iron from the mains.
CARE AND CLEANING

Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled down.

Do not use abrasive cleaners.
SELF-CLEANING

Fill water reservoir up to the maximum level and then close it.

Set the temperature control to its maximum position, set variable steam control to its minimum position.

Insert the main plug into the wall socket, and wait for the indicator light to go out. Remove the iron from the base.

Holding the iron horizontally over the sink press the selfclean button.