Fig. 2 Sweeper Control Panel Layout
BEACONS
AUXILIARY ENGINE STOP
AUXILIARY ENGINE
PANEL ON/STAND-BY
LEFT HAND
LEFT NOZZLE
WIDESWEEP
LEFT SIDE WATER
RIGHT HAND
RIGHT NOZZLE
RIGHT SIDE WATER
LEFT SIDE
RIGHT SIDE
HIGH-PRESSURE WATER PUMP •
LIQUID CRYSTAL DISPLAY
AMBIENT LIGHT
START
SENSOR
(LCD SCREEN)
WORK LIGHTS
RAISE/LOWER
SIDE-BRUSH
WORK LIGHTS
SIDE-BRUSH
RAISE/LOWER
SUCTION FAN
WIDESWEEP WATER
• indicates optional equipment
SIDE BRUSH
NOZZLE TILT (MOMENTARY)
When in Sweep Mode:
UPPER LINE = ENGINE SPEED
LOWER LINE = WATER TEMPERATURE / WARNINGS
MANUAL
PRE-HEATERS
SWING IN/OUT
NOZZLE TILT (LOCKING)
SWEEP MASTER
SWITCH
SIDE BRUSH DOWN PRESSURE •
OPTION
SCARAB M6 SWEEPER KIT
Amdt.1 - 03 November 2009
Operator’s Manual
8
AUXILIARY ENGINE START SWITCH
- Press and hold until the auxiliary engine
starts. Red LED illuminates while heaters are active then, after a few
seconds, the red LED extinguishes and the green LED illuminates,
remaining permanently lit. When the auxiliary engine starts the switch’s
backlight extinguishes and the switch is disabled to protect the starter
motor. At the same time the auxiliary engine STOP switch backlight
illuminates, confirming that the switch is now enabled.
AUXILIARY ENGINE STOP SWITCH
- Press and hold until the auxiliary
engine stops. Red LED illuminates while the switch is being pressed. When
the auxiliary engine stops the switch’s backlight extinguishes and the
auxiliary engine START switch backlight illuminates.
