12
496236 Issue 4
3. Installation
3. INSTALLATION
Installing the alarm system comprises the following steps:
1.
Run cables from the position of the detectors, any remote keypad, and
external sounders to the control panel position.
2.
Fit the control panel, detectors, remote keypad, and external sounders in
their chosen locations.
3.
Connect the mains cable with power OFF and fit the standby battery (do
not connect the battery at this stage).
4.
Connect the remote keypads (if fitted).
5.
Connect the detectors (but NOT to the 12V AUX supply at this point).
6.
Connect the external sounder. Do not complete the connection to the
12V terminal on the lower connector at this stage.
7.
Apply power (battery and mains) for the first time.
8.
Connect the external sounder to the 12V terminal on the lower connector
and the detectors to the 12V AUX terminal.
9.
Program the system (see "4. Programming").
10. Hand over to the user.
Fitting the System
Fitting the Control Panel
(a) Remove the control panel from the packing.
(b) Remove the front screw and open the hinged lid to the left. Note the
slotted central keyway located at the top of the back box.
(c) Mark and drill the centre hole and temporarily fix the panel to the wall.
Now mark the remaining holes, remove the panel and continue to drill the
other two holes.
(d) Refit the panel to the wall using not less than 30mm x No 8 Dome or Pan-
head screws.
Note:
Do not drill the holes with the panel in position as this may result in damage to the
electronics.
Fitting a Remote 9427 Keypad
Figure 6 shows the 9427 keypad.
1.
Lift the flaps on the faceplate of the keypad and undo the four screws
holding on the back of the case.
2.
Hold the keypad back in place and mark, drill and plug the position of
keyhole.
Summary of Contents for 9448+
Page 1: ......
