Installation Instructions
Installation
The 9066 has mounting holes for fitting into the standard "Eurobell" base and is supplied
with plastic mounting pillars.
Figure 2 below shows typical connections to a control panel.
Figure 2. Typical Connection to Control Panel
1. Connect the Bell to O/P +ve and -ve.
2. EITHER:
a)
Connect Strobe to O/P +ve and -ve to ensure the strobe stops when the bell
stops.
OR
b)
Connect one lead from the strobe to O/P +ve. Connect the other lead to the
STRB output from the panel if you require the strobe to continue flashing after the bell
has stopped.
3. If necessary:
a)
Cut LK1 for continuous bell (disables 9066 timer).
b)
Cut LK2 for -ve applied trigger.
c)
Cut LK3 for +ve tamper return.
4. Link - Hold to Batt -ve. NOTE: This link connects the module's battery to the supply
from the panel. The module will not work correctly without the link.
5. Complete the other connections as shown in Figure 2.
6. Make sure the bell box lid is in place and the tamper switch closed. The module will
not function correctly with the tamper switch open.
Testing
Note: During the initial installation the installer must reset the internal 9066 timer. To
do this make sure that all wiring is connected and the tamper switch is closed. The
9066 will not operate correctly until this procedure is complete.
If you wish to test the module without letting the bell run for a full 20 minutes, short
together the minipins marked "Test". When the module is triggered the 9066 internal
timer will switch off the O/P terminals after 15 seconds.
9066 Bell Module
Control Panel Output
Strobe
Bell/Sounder
Link to enable
DEAC battery
123456789
123456789
123456789
123456789
123456789
123456789
123456789
123456789
123456789
Enclosure
Tamper
switch
Optional Strobe connection
Do not connect to O/P on
module if this method
chosen
Trig
0V
+12V
TR
STRB
- Hold
Batt -ve
Tamp Ret
Trig
Tamp
+ Hold
- ve
+ ve
O/P
MANUFACTURED IN THE UK BY SCANTRONIC LTD. PRODUCT SUPPORT (UK) - TEL - (0891) 616343 BETWEEN 09:00 AND 17:30,
MONDAY TO FRIDAY. (CALLS CHARGED AT 39P PER MINUTE CHEAP RATE, 49P PER MINUTE AT ANY OTHER TIME.) PRODUCT
SUPPORT FAX NO. (01594) 544136.
