Scantool PV 30, Manual, Page: 6 / 32

6
2.0 GENERAL SAFETY TERMS
2.1 Machine's Safety Accessories and Accident Prevention Terms
The machine is provided with fixed shelters for the protection of all gears. But some mobile
parts, because of their shape for the bending processing cannot be protected within a case.
However, safety is guaranteed by the machine features and by the use of "human presence"
controls.
The machine is controlled by means of foot-pushed buttons present at the downside of the
Mobile Control Panel. During operation the specified safety distance must always be
observed.
There is a red mushroom emergency button at the upside of the Mobile Control Panel to stop
all the machine activity by disabling the electric supply until released. In case of an
extraordinary situation, please push this button straight away.
No other persons except for the qualified and well trained operator should be allowed to use
the machine and to be present in the working area of the machine.
Any damaged or defective connections to the different energy supplies must be resplaced.
All interventions concerning installation, start-up, change of equipment, use, change to the
use and the operation, regular maintenance, inspection and periodical maintenance can be
performed only after disabling the machine according to relevant chapter of this handbook.
2.2 Abnormal Conditlons
In order to avoid unusual working conditions, in the following several recommendations to the
operator are listed. Also, do not forget that this machine can be used only in the conditions
presented in this operation and maintenance handbook
Before connecting the machine double-check electrical connections read the instructions
carefully. For, almost 65% of the failure resports we receive are based on either wrong
electric connection or use in contradiction to the User's Manual
Avoid the approach of persons to the operator while the machine is running.
Loading and unloading of the material should be done according to the instructions of this
handbook.
During the bending process avoid holding material with the hand.
Never wear garments with Ioose parts, which may be dragged by the machine parts, long
loosehair, necklaces, rings etc.
Never use goods except for the allowed ones as operational materials.
Never run the machine without safety devices.
Don't climb on the machine.
The machine cannot be installed and used in corrosive environments.
The machine must always be operated with one qualified operator who has the required
knowledge to use this machine properly.