Scantool PV 30, Manual, Page: 13 / 32

13
Note: The manufacturer doesn't accept any responsibility for damages due to the non®
observance of the above specifications.
Note: All of machines must adjust goodly and carefully to fake smooth working from machine.
Machine adjustment must make with water gauge. The water gauge's picture is given below.
8.0 OPERATING PV 30 HORIZONTAL
Before positioning the machine it is necessary to leave
enough working area for the proper bending operations such
as: extraction ' of the cylindrical profile, feeding of the semi
product, bending of big diameters.
If you have no alternative to install the machine in a broad
area but a low height area, then there is a solution to this
problem as shown in figure 1.
To set the machine horizontally follow these steps:
1. Dismantle the screw shown by (1)
2. Rotate the machine 90°
3. Fit the screw to the hole shown by (2)
Following figures are aspects of the machine adjusted
horizontally.
Attention: Note that in the figure 3, the area bordered by
thick line shows the forbidden zone for a second person to
enter for safety reasons.