Scantool PV 30, Manual, Page: 15 / 32

15
8.1 Materials and Products
The machine is mainly steel and it is not designed for handling inflammable or detrimental
products. It is duty of the customer to check if the processed materials respond to these
requirements. Also, it is duty of the customer to check if the processed materials can be
dangerous for the operator working nearby.
When selecting the most appropriate operation material you should keep in mind those
instructions:
Material must be clean out of oil and dry.
2. Hardness value must always be same thorough the material. So, we recommend you to
buy certificated steel.
3. Parts to be bended should have smooth surface to fulfill the procession correctly and
easily.
Note: The thorough cleaning of the rolls is absolutely necessary in order to avoid possible
sliding of the prohle due to grease residues on the rolls.
8.2 Electrical Connection
Have a qualified electrician connect the machine to the electric supply. In some cases inverse
electrical connection causes the motor bum out To avoid such an undesirable event, after
having connect the machine see that the motor turns to the direction shown by arrow when
activated. Or you can check to see if the rolls are rotating to the same direction of the pedals.
That is, if the right pedal is pushed, the rolls should rotate right and if the left pedal. is
pushed, the rolls should rotate left. If the machine does not comply then inverse the electric
cables.
8.3 Electric Box
The SC-30´s electric box includes very important controls
of the machine and is also connected to the below shown
foot pedals. The keys on the electric box are shown and
explained here:
1. Electric box lock
2. Speed selector
3. Start indicator
4. Electric on indicator
5. Main switch
6. Foot pedal plug-in
7. R S-T phases plug-in
8. Electric plug-in
9. Digital connection