MODEL MB-45
MODEL MB-45
Operator’s manual for Drilling Machine
- 5 -
14) Use tools recommended
in Operator’s Manual only.
15) After use, always clean drilling machine from metal chips and coolant.
16) Always unplug machine from power supply during any work on the machine.
17) In the case that the machine falls on a hard surface, from a height, is wet or is
subjected to other unfortunate events that could affect its technical state - work should
be terminated immediately and the machine should be sent to service for inspection as
soon as possible.
It is not allowed to use drill on steel thinner than (less than 3/8” (10 mm)). On
thin steel (less than 3/8” (10 mm)) magnet’s adhesive power would be
significantly reduced what can cause machines failure or individuals injury.
The machine should be located on the work piece with the entire surface of the
electromagnetic base! It is recommended that each time, before positioning the
machine surface under the electromagnetic base should be sanded down with
abrasive paper!
Please keep all recommendation.
