Scanstrut Ltd. 1 Malt Mill, Totnes, Devon, UK TQ9 5NH
Tel:
+44(0)1803 863800
Fax:
+44(0)1803 862223
e-mail:
website:
www.scanstrut.com
Installation Procedure
1.
Place the SC50 wedge assembly in the required position with the wedge base
seal downwards on the deck/arch.
2.
Counter rotate the two halves of the Satcom Wedge assembly until a
horizontal plane is created.
3.
Place the Satcom adapter onto the horizontal plane created on top of the
SC50 wedges. Correctly align the Satcom adapter fore and aft with respect to
the desired orientation of your Satcom Antenna.
4.
Mark through the adapter and SC50 Wedges to the deck with the position of
the 4 mounting holes in the Satcom adapter base.
5.
Drill clearance holes for 8mm bolts
vertically
through the deck/arch so that
the bolt heads will be aligned with the inner surface of the Satcom Adapter.
6.
Secure the assembly to the deck using 8mm bolts, the 6° Washer pairings
and lock nuts. When tightening the nuts, the 6° Washers should counter
rotate in a similar way to the SC50 wedges to create a plane perpendicular to
the bolts for the nuts to tighten up against.
7.
With the SC50 and Satcom adapter assembly complete, install the antenna as
described in the Satcom Adapter mounting instructions.
