Scanstrut Ltd. 1 Malt Mill, Totnes, Devon, UK TQ9 5NH
Tel:
+44(0)1803 863800
Fax:
+44(0)1803 862223
e-mail:
website:
www.scanstrut.com
Fitting SC110 and SC113
Note: Steps 1 and 2 for SC110 only
.
1.
SC110 is pre-drilled to fit Perko 200, Aqua Signal 25 & 45 series and Hella Marine
2984 Series lights.
2.
Fit light to top mount plate as per mounting instructions for your light. The cable
should be routed down through the SC110 and out through the slot on the underside
of the tube.
3.
The SC110 and SC113 fit to the underside of the PowerTower at the port side.
4.
Remove the two fixing bolts that hold your radar in place and use them to loosely
secure the SC110/SC113 to the underside of the PowerTower. We advise placing
some Stainless Steel washers under the heads of the fixing bolts to spread load over
a greater area.
5.
With the fixing bolts loosely secured, slide the SC110/SC113 fore/aft to your
preferred position. Tighten the fixing bolts securely.
6.
The cable can now be routed through the rubber grommet in the rear of the
PowerTower.
Fitting SC111 and SC112
The SC111 and SC112 are designed for the installation of GPS antenna and ‘Whip’ type VHF,
HF/SSB, AM/FM, and cellular antenna of up to 1m in height, that have the standard 1” x 14TPI
thread as their fixing. SC111 and SC112 are designed to work with Pacific Aerials P6161/P6162
adapter for their Pro range of antennas.
1.
Thread the cable of your antenna down through the threaded boss at the top of the
SC111/SC112 and out of the slot on the underside of the tube.
2.
Attach your antenna to the threaded boss at the top of the tube.
3.
The SC111 and SC112 fit to the underside of the PowerTower. SC111 on the
starboard side, the SC112 to the port side.
4.
Remove the two fixing bolts that hold your radar in place and use them to loosely
secure the SC111/SC112 to the underside of the PowerTower. We advise placing
some Stainless Steel washers under the heads of the fixing bolts to spread load over
a greater area.
5.
With the fixing bolts loosely secured, slide the SC111/SC112 fore/aft to your
preferred position. Tighten the fixing bolts securely.
6.
The cable can now be routed through the rubber grommet in the rear of the
PowerTower.
