Scan Combiflex 450 – Manual
Chapter 4
- 58 -
To empty the water tank before lying down transport, increase the water flow to a maximum and
let the water pour out. Make sure the tank is empty before lying down transport.
Empty the tank before long time storage.
4.7 Start up the SC 450NS
See ”
4.1Precautions
” before starting the machine.
How to start the machine
§
Make sure that the power plug and hoses for dust collector and water (if water supply is
used) are connected to the machine.
§
Turn on the dust collector if used.
§
Push the handle downwards to lift the gear barrel about 10 cm (4”) from the ground.
§
Make sure that the “EMERGENCY STOP” is in its upper position.
§
Press the “START” button on the control panel.
§
Lower the gear barrel down to the floor.
4.8 Emergency stop / Reset SC 450NS
Use the Emergency Stop button to quickly stop the machine to prevent an accident or injuries.
Reset procedure:
•
Turn the Emergency Stop button clockwise to release it
•
Press the Stop button
The machine is now ready to be started again.
4.9 Stop the SC 450 NS
How to stop the SC 450NS machine
§
Press the “STOP” button.
§
Wait for the machine to come to a complete stop before letting go of the handle.
§
Turn off the dust collector if used.
4.10 Grinding speed SC 450NS
Use the “SPEED” dial to adjust the rotation speed of the grinding discs between the intervals
described in chapter 1.
4.11 Rotation direction SC-450 NS
Use the “L/R” switch to change direction of the grinding discs. The machine will first do a soft
stop then a soft start.
Scan Combiflex 450 – Manual
Chapter 4
- 59 -
4.12 Safety off position
When working on the machine, maintenance or tool change, the machine must be set to the
“Safety off position”. See “
2.7 Definition of the “Safety off position”
” for further information.
4.13 Grinding
Refer to “
Grinding guide
” for instructions and information about grinding.
4.14 Changing tools
Before changing tools, read “2.8 Safety regarding maintenance”.
This illustration shows how to change the tools.
Figure 4-4
How to fit the diamond tools on the Scan-On plate
§
Insert the segment at the widest part of the slot
§
Push the segment outwards
§
The segment is now fit on the Scan-On plate
To make sure that the tool is secured, use a small plastic hammer and slightly hit the tool
outwards. In reverse this technique can be used to loosen tools that are stuck.
58
59
ENGLISH
www.scanmaskin.com
www.scanmaskin.com
SCAN COMBIFLEX 450/450NS
