SCANMASKIN 28 WS, Manual

Page: 95 / 410

4.13
Wheel release system SCANMASKIN 28 RC
The SCANMASKIN 28 RC machine is equipped with a drive system for the wheels. This can easi-
ly be released so the wheels are free spinning. Note that the machine must stand on a level sur -
face and that there is no load on the wheels. Follow the steps described below:
4.14
Changing tools
Before changing tools, read “2.8Safety regarding maintenance”.
This illustration shows how to change the tools.
Figure 43 How to fit the diamond segments on the Scan-On plate.
1 Insert the segment at the widest part of the slot
2 Push the segment outwards
3 The segment is now fit on the Scan-On plate
To make sure that the tool is secured, use a small plastic hammer and slightly hit the tool out -
wards. In reverse this technique can be used to loosen tools that are stuck.
4.15
Using with generator
The generator must be equipped with protective earth and operated in accordance with the
current EN-VDE directives (this applies to the protective earth conductor in particular) in or-
der to ensure that all safety devices are functioning and eliminate possible damage to elec -
trical components.
ENGLISH SCANMASKIN 32 WORLD SERIES
95
www.scanmaskin.com