#SC 40RT 06 – 101027
Page 24 of 44
• Make a complete survey of
the dun unit below deck
- Inspect nozzle and flow
guides so no particles are
stacked
- Inspect the bearings at the
nozzle housing
- Change parts if particles
are stacked in the bearings
or if bearings are worn out.
•
NOTE!
When replacing old
bearings (pos. 131) at the
nozzle housing, the thrust
bearing (pos. 130) should be
screwed in by hand to finger tight position and then
unscrew ½-¾ turn
prior to fit the splitpin
(pos. 129). This is important to get the correct
clearance for flushing the bearings during cleaning.
• A service card is included with this manual; see page 43. This should be
completed each time service is performed on your tank cleaning machine
to maintain a proper record/
history.
Every 24 month or every 300h
operation, whichever comes
first
• Perform the same inspection
as described above
• Also inspect, and change
if necessary, the turbine
shaft (pos. 108) by removing
drive unit and open cover to
magnetic transmission. Check
the upper shaft (pos. 103) and
turbine shaft (pos. 108) for
wear. Change if necessary.
Grease thread
with DEPAC
antiseize grease
Protect!
Upper shaft
(pos. 103)
Turbine/lower shaft
(pos. 108)
Designer
Date
Date
Drawer
Surface treatment
Weight
Note
Dimension
Material
General Tolerances
Tolerance ISO 2768-m Gen. surface
N9
This document is our property and shall not without our permission in writing be altered, copied, used for manu- facturing or communicated to any person or company.
Drawing no. / Ritningsnr.
Format
SC40RT
A4
Scale
SC40RT
1:5
SC40RT
Denna handling är vår egendom och får ej utan vårt skriftliga medgivande ändras, kopieras, användas för tillverkning eller delges annan person eller firma.
SS-ISO 2768-m for machined parts
(30)-120=
0.3
0.5-3=
0.1 (120)-315=
0.5
(3)-30=
0.2 315)-1000=
0.8
P03.1
Törnedalsgatan 1, 275 21 Sjöbo
SWEDEN
ML
Revision
05-04-19
E
No.
Revision note
Date
Sign.
Qty.
Ins.
gram
129
131
130
131
Designer
Date
Date
Drawer
Surface treatment
Weight
Note
Dimension
Material
General Tolerances
Tolerance ISO 2768-m
Gen. surface
N9
This document is our property and shall not without our permission in writing be altered, copied, used for manu- facturing or communicated to any person or company.
Drawing no. / Ritningsnr.
Format
A4
Scale
1:5
Denna handling är vår egendom och får ej utan vårt skriftliga medgivande ändras, kopieras, användas för tillverkning eller delges annan person eller firma.
SS-ISO 2768-m for machined parts
(30)-120=
0.3
0.5-3=
0.1 (120)-315=
0.5
(3)-30=
0.2 315)-1000=
0.8
Törnedalsgatan 1, 275 21 Sjöbo
SWEDEN
Revision
E
No.
Revision note
Date
Sign.
Qty.
Ins.
gram
