30
Installation instructions
|
SCANIA Interlock
®
7x00
|
Disposal
2. The display message on the handset shows:
Ready for test. Please blow
.
3. The vehicle
must not
be started now.
4. No permanent error messages in the display cockpit of the vehicle.
5. Provide a breath sample.
6. The display message on the handset shows:
Test passed
followed by the
Free Start Time:
.
7. The vehicle can now be started.
8. The display message on the handset shows:
Drive Safely!
.
9. If the vehicle is an automatic, the Interlock
must not
switch to the free start
time during the stop phase.
10. If a retest is requested, the engine
must not
switch off.
11. Switching off the ignition/exiting the vehicle (with Keyless Go).
12. Interlock immediately switches to the free start time.
13. The engine may be started again without providing another breath sample
within the free start time. The Interlock then changes back from
Free Start
Time:
mode to
Drive Safely!
mode.
14. If the engine is not switched on again, the Interlock switches off
automatically once the free start time has expired.
15. The engine can be switched on again after expiry of the free start time once
a successful breath sample has been provided.
4.10 Installation certificate
●
After installation, complete the installation certificate contained in the
instructions for use.
4.11 Instrument setting and calibration
This work may only be carried out by an authorized Dräger-Interlock service
centre.
●
If required, set the variable device settings on the device.
●
Calibrate the device, if necessary.
4.12 Removing
the
Interlock
4.12.1 Disconnecting the vehicle battery
NOTICE
Disconnecting the vehicle battery may erase battery-dependent instrument
settings (e.g., the anti-theft code for the radio or the preset stations). On some
vehicles, disconnecting the vehicle battery may turn the air-bag light on, which
can then only be turned off by the vehicle manufacturer.
●
Disconnect the earth lead from the vehicle battery before doing any work.
4.12.2 Detaching
the connecting leads
1. Detach the positive lead (red), earth lead (black), ignition lead (blue) and the
door contact lead (white) for the control unit from the cable harness of the
vehicle.
2. If required, also disconnect the control unit's horn, headlights and D+ lines
from the vehicle's cable harness.
3. Protect open leads of the cable harness against short circuit and corrosion
with high-quality insulating tape or thermo shrinkable tubing.
4. Disconnect the control unit's starter relay lines (grey and brown) from the
vehicle's cable harness and join the two starter relay lines of the cable
harness via soldering.
5. Protect the connection against short-circuit and corrosion, e.g. using a
thermo-shrinkable tubing.
6. After removing the device, re-connect the vehicle battery.
5 Disposal
Dispose of the product in accordance with the applicable rules and regulations.
This product must not be disposed of as household waste. This is indi-
cated by the adjacent symbol.
You can return this product to Dräger free of charge. For information
please contact the national marketing organizations or Dräger.
