Web Setting Function:
System provide detail settings over web browser, you could input the IP address of transmitter / receiver
at link column of browser if you know the exact IP address of them.
How to get the IP address of receiver:
1. Connect monitor with receiver,
local IP
shows on right bottom screen when receiver booting or
transmitter not connected( or no video input)
2. Press remote control button
MENU, 1, ENTER
(Network Information), it will shows the receiver IP
Address on screen
How to get the IP address of transmitter:
1. Connect monitor with receiver, connect receiver with transmitter and set in the same
channel,
remote
IP
shows on right bottom screen when receiver booting or no video input from
transmitter
Set IP address of transmitter/receiver by command:
Press and hold panel button “+” then power on to set factory default then enter engineering mode. In
engineering mode Power and Link LED will be flash together, IP address of unit will be set to Static IP
192.168.0.88 temporarily, login to the web page by browser and change IP settings in API commands
column as below(
x
can be one of numbers
1~254
):
astparam s ip_mode static
astparam s ipaddr
169.254.x.x
astparam s netmask
255.255.0.0
astparam save
Commands can be applied one by one, or connected them by “;” to apply at once as below:
astparam s ip_mode static;astparam s ipaddr
169.254.x.x;
astparam s netmask
255.255.0.0;
astparam save
Also you could use private IP address/subnet mask you preferred like
192.168.x.x
/
255.255.255.0
