3
139234_Rev_A 9.17 .10
Unpacking the Fireplace
1. A Miscellaneous Hardware Kit is packed within
the firebox crate. It contains:
• Installation / Operation manual
• Fuel Conversion Kit, LP
• Leg Leveler Brackets, two each - left and right
• Leg Leveler Bolts, 4
• #10 x 1/2” Sheet metal screws, 8
2. Remove Pallet Bracket screws - two on each side.
3. Remove the Latch Tool and Stabilizer Bar which
are screwed to the pallet.
4. Use the Latch Release tool to remove the fireplace
glass frame in order to install the log set and
other accessories.
Locate the left and right trunk latches on the
underside of the firebox floor. See fig. 1.
Release each latch by engaging the tangs of the
tool with the latch release, pulling it forward.
Pull the Glass Frame away from the Firebox and
lift to disengage it from the retaining lip at the
top of the firebox. Set the glass out of the way.
5. The Starfire Glass Embers or Tumbled Stone
burner media is packaged separately from the
insert firebox.
Figure 1. Pull each Trunk Latch down to disengage it
from the Glass Frame.
G
lass Frame Latch
Locations
Table of Contents
Installation & Service Tools
.........2
Unpacking the Fireplace
................3
Specifications
....................................4
General Information
........................5
Safety Information
..........................6
Installation
Fireplace Requirements .............. 7
Hearth Protection ..........................7
Clearances ........................................9
Vent Guidelines .............................10
Masonry Fireplaces ......................11
Prefabricated Fireplaces ...............12
Vent Requirements .......................13
Fireplace Assembly
Gas Connection ............................. 14
Gas Pressure................................... 14
Fuel Conversion .............................16
High Altitude Adjustment .......... 18
Flame Picture Adjustment .........19
Optional Glass Panel Kits .......... 20
Burner Media Installation ...........21
Wall Thermostat ...........................22
Remote Control ...........................22
Surround Assembly ......................23
Operation
Burner Controls ............................24
System Check ................................25
Blower Controls ...........................25
Maintenance
Annual Cleaning .......................... 26
Glass Replacement ...................... 26
Illustrated Part Breakdown
.........27
Appendix /
Wiring Diagrams,
Approved Vent Manufacturers
........
29
Warranty Statement
................... 30
Lighting Instructions
......................31
