Scan-Electronics RadiaCode-101, User Manual, Page: 22 / 36

20
© 2021 Scan Electronics Ltd.
Standalone usage
The structure of the "Settings" submenu with its brief description is shown below:
Display units
Selection of the assessment type of radiation intensity for Monitor mode: dose
rate or count rate. This type affects the display units which also depend on
Measurement units : Sv/h or R/h for dose rate selection, CPS (counts/s) or CPM
(counts/min) for count rate selection.
Measurement units
Selection of measurement units:
for dose (dose rate): Sv (Sv/h) or R (R/h);
for count rate: CPS or CPM.
Dose rate Setting thresholds 1 and 2 for dose rate alarms.
Dose Setting thresholds 1 and 2 for dose alarms; accumulated dose resetting.
Screen Selection of display backlight and rotation modes.
Signals
Global: turning on/off the sound and vibration signaling;
gamma quanta registration: turning on/off the sound (clicks) and light signaling;
alarms and buttons: separate turning on/off the sound and vibration signaling.
Bluetooth Bluetooth turning on/off.
Language Language selection: English, Russian.
Time Setting current time.
Device info
View the information about the device: serial number, firmware version and
bootloader version.
Factory settings Calling up the menu for reset device settings.
To return to the top level or quit the menu (while in the "Settings" ):
·
set focus on the [<Back] or [<< Menu quit] item
according to your choice;
·
confirm your choice by short pressing the round
button.
3.8.1 Display units
Use [Display units] item of Settings to select the presentation type of measurement results for Monitor
mode - dose rate or count rate:
·
while in the Settings , set focus on the [Display
units] by short pressing the swing buttons;
·
select the presentation type by short pressing
the round button.
Display units depend on Measurement units : Sv/h or R/h for dose rate selection, CPS or CPM for count
rate selection.
If required, go to next items of Settings by short pressing the "up" and "down" swing buttons.