Scan-Electronics RadiaCode-101, User Manual, Page: 18 / 36

16
© 2021 Scan Electronics Ltd.
Standalone usage
USB connection established.
Bluetooth connection established.
All sounds are turned off.
Separately permitted sounds are turned on.
Alarm level 1.
Alarm level 2.
The following icons represent standard device information:
·
Alarm sign: exceeding thresholds for dose rate or accumulated dose - presence and level.
·
Sound status: on, off.
·
External connection sign: presence and type - USB, Bluetooth.
·
Swing buttons control sign: locked, unlocked.
·
Built-in battery status: charge level (4 variants), charging, powered from the external source (end of
charging).
Example of the standard status information is shown below:
·
exceeding threshold 1 for the dose rate or accumulated dose;
·
sounds are enabled;
·
USB connection established;
·
swing buttons are locked;
·
battery is charging.
Note: In all Display modes, a long press on the swing button "up" global turns on and off the
sound signaling.
3.7.1 Monitor
Monitor mode is designed to represent the dose rate or count rate. When the device is turned on, it
starts to work in this display mode.
In the Monitor display mode (see also Display units ), the screen
represents:
·
status bar - at the top;
·
vertical graphic scale of the dose rate or count rate - at the left;
·
numerical value of the dose rate or count rate with its error level - at the
center and on the right.
All incoming data is accumulated and analyzed. When a change in the radiation environment is
detected, dosimeter starts a new interval of data accumulation. In the absence of changes in the
radiation environment, data averaging continues in order to increase the reliability of the assessment.
If any of the alarm thresholds for the dose rate or accumulated dose level is exceeded, the corresponding
alarm will be triggered. To stop the dose rate alarm, place the device in location with a normal
background radiation level. Then, you need to confirm that you have received the alarm with a
short press
on the round button.
There is a standard information of Display modes on the right side of status bar.
The following information is shown on the left side of status bar:
Current time
Radiation sensor temperature