![background image](http://html1.mh-extra.com/html/scag-power-equipment/stt-31bsg/stt-31bsg_operators-manual_1205882015.webp)
Section 6
24
Cutter Deck Height
The cutter deck height adjustment is made to ensure that
the cutter deck is cutting at the height indicated on the
cutting height index gauge. To check for proper deck
height, be sure that the mower is on a flat, level surface
and the tires are properly inflated.
1. Place the cutter deck in the transport position.
Loosen the jam nuts on both ends of the deck height
control rod. (See Figure 6.6)
Figure 6-6. Cutter Deck Height Adjustment
2. Turn the control rod (See Figure 6.6) until there is a
1/4" space between the rear deck stop and the top of
the cutter deck. (See Figure 6.7). Tighten the jam
nuts on the control rod.
Figure 6-7. Cutter Deck Stop
3. Check the cutter deck cutting height by placing the
lanyard pin in the 3" position on the cutting height
index. Release the deck from the transport position
and allow the deck to move to the 3" cutting height
position.
4. Check the measurement from the floor to the cutter
blade tip. If the measurement is not at 3", an
adjustment can be made using the deck height
control rod. (See Figure 6.6)
-NOTE-
If an adjustment had to be made, be sure that the
cutter deck can easily be locked into the
transport position.
1/4"
DECK
STOP
390S0175-1
CUTTING
HEIGHT
6
5.5
5
4.5
4
3.5
3
2.5
2
1.5
1
481543
390S014A-1
HEIGHT ADJUSTMENT PEDAL
LANYARD
PIN
LOOSEN HERE