![background image](http://html1.mh-extra.com/html/scag-power-equipment/liberty-z/liberty-z_operators-manual_1205813035.webp)
31
R
Section 7
7.4 ENGINE OIL
A. CHECKING ENGINE CRANKCASE OIL LEVEL
The engine oil level should be checked after every 8 hours
of operation or daily as instructed in the Engine Operator’s
Manual furnished with this mower.
B. CHANGING ENGINE CRANKCASE OIL
After the first 8 hours of operation, change the engine
crankcase oil and replace the oil filter. Thereafter, change
the engine crankcase oil after every 50 hours of operation or
yearly, whichever occurs first. Refer to the Engine Operator’s
Manual furnished with this mower for instructions.
C. CHANGING ENGINE OIL FILTER
Replace the oil filter after every 100 hours of operation.
Refer to Engine Operator’s Manual for instructions.
ENGINE OIL FILL
& DIPSTICK
ENGINE OIL FILTER
9. Reinstall the fill port plug on the top of the transaxle.
10. The hydraulic system will need to be purged of
all air. Raise the rear of the machine so the drive
wheels are off the ground. Use jackstands and block
the front caster wheels to prevent the machine from
moving.
11. Move the dump valve controls to the "freewheel"
position by pulling the levers backward and locking
in the notch (towards the rear of the mower). See
Figure 7-4.
2015 SPZ-DVL
DUMP VALVE
CONTROL LEVER
"DRIVE" POSITION
Figure 7-4. Dump Valve Control Lever
12. While in the operator's position, start the engine and
disengage the parking brake.
13. Run the engine at 1/2 throttle and move the steering
control levers to full forward and reverse 5 to 6 times.
14. Engage the parking brake. Move the dump valve
control levers to the "drive" position. See Figure 7-4.
15. While in the operator's position, run the engine at
1/2 throttle. Release the parking brake, move the
steering control levers to full forward and reverse 5
to 6 times. It may be necessary to repeat steps 12 to
15 until the air is completely purged from the system.
16. After the purge process is complete, remove the side
top port plug from both transaxles to check the oil
level. See Figure 7-2. If necessary, fill oil until the oil
just appears at the bottom of each axle top port.