INSTALLATION
Please note:
All devices, lighting effects and crossbeams attached on a stand must be secured with a
secondary attachment!
1. Attach an appropriate adapter or TV-adapter to the top end of the stand and fasten it with the fixation
screw.
2. Attach the mounting bracket of the follow spot onto the TV-adapter and tighten the fixation screw.
3. The given carrying capacity of the stand must not be exceeded. Please consult the appropriate user
manual for further information.
4. To align the device, release the fixation screws at the mounting bracket, adjust the desired
inclination angle and retighten the fixation screws.
5. After installation, the device requires inspections periodically to prevent the possibility of rot,
deformation and looseness.
CONNECTIONS
DMX512 control
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the light set with a DMX cable.
2 Connect the DMX output DMX OUT of the light set to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
XLR connection:
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2 To switch off the unit, disconnect the power plug.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.