Warning – risk of burns and fire
�
The admissible ambient temperature range (Ta) is -5 to +40°C. Do not operate the device outside of
this temperature range.
�
The housing temperature (Tc) can be up to 50°C during use. Avoid contact by persons and materials.
�
Do not illuminate surfaces within 50 cm of the device. This value is indicated on the device
by the symbol.
- - -m
�
Do not use the device near highly flammable materials. Always place the device at a location where
sufficient air circulation is ensured. Leave 50 cm of free space around the device. Never cover the air vents
of the housing.
�
Only operate the device in moderate climate, never in tropical climate.
Warning – risk of injuries
�
Do not look directly at the light source. Persons with light-sensitive epilepsy may suffer from epileptic
seizures or fall unconscious.
�
Make sure that the product is set up or installed safely and expertly and prevented from falling down.
Comply with the standards and rules that apply in your country, in particular EN 60598-2-17.
�
If you lack the qualification, do not attempt the installation yourself, but instead use a professional
installer. Improper installation can result in bodily injury and or damage to property.
�
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient
safety precautions.
�
For overhead use, always secure the device with a secondary safety attachment such as a safety
bond or safety net.
�
Make sure that the area below the installation place is blocked when rigging, derigging or servicing
the device.
�
For commercial use the country-specific accident prevention regulations of the government safety
organization for electrical facilities must be complied with at all times.
Caution – material damage
�
This device must not be connected to the mains voltage by means of a dimmer.
�
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure
that the device will serve you for a long time without defects.
�
Never switch the device on and off at short intervals. This will considerably reduce the service life of
the device.
�
If the device has been exposed to drastic temperature fluctuation, do not switch it on immediately.
The resulting condensation may destroy the device. Allow the device to reach room temperature before
connecting it. Wait until the condensation has evaporated.
�
Please use the original packaging to protect the device against vibration, dust and moisture during
transportation or storage.
�
If a serial number label is affixed to the device, do not remove the label as this would make the
guarantee void.