5
OPERATION INSTRUCTIONS
Opening and closing the damper
A. Open the damper before starting a fire.
• Pull handle down slightly and release, allowing lug to
pull up and hang freely about 7” above the bracket.
(see illustration). If lug only hangs 1” to 2” above
bracket, damper may not be open.
Warning: Do not start a fire if damper is not clearly
open. Failure to follow this rule may cause smoke
damage.
B. Close the damper after the fire is completely out.
• Pull handle down until lug is below bracket. Move
cable into any notch in bracket and release handle.
C. If damper does not open
• This may occur due to heavy snow, ice, or improper
installation.
• Pull the handle down sharply 3” to 4” below the
bracket. This pulls down the extra cable leg to pull the
lid open.
• Release the lug up past the bracket.
• If necessary, inspect the damper on your roof to
determine how to get it open, or call your local CSIA or
WETT certified chimney sweep to do the inspection.
Energy saving note: Closing the damper when
fireplace is not in use will prevent heated or air
conditioned air from escaping out the chimney
Fire prevention warning: Remember to have your flue checked annually for creosote
buildup by your local CSIA or WETT certified chimney sweep.
