36
CONFERENCE CALL
Your new 2-line cordless system supports conference calls up to 4 parties :
•
1 handset, the base unit and 1 external call ;
•
1 handset and/or the base unit and 2 external calls on a single line ;
•
1 handset and/or the base unit and 2 external calls on different lines;
Handset and base unit conference call
W hen engaging an external line on the handset, press
the Line key with the in use indicator lit on the base unit
to enter a conference call.
“CONFERENCE” (or CONF in handset), Line num ber
and engaged handset num bers (0 stands for base unit)
appear on the displays.
Press [Bye] on the base unit or on the handset will only
end that party from the call. To end the call, make
sure all parties have disconnected from the line.
Note:
This phone system can allow you to conference or intercom by using the handset and
base sim ultaneously. If the handset is operated too close to the base unit, you m ay
experience feedback noise. Should this occur, move the handset away from the
base unit and the feedback will stop.
Single line conference call (3 W ay calling)
W hile on a call, press [3W AY] softkey to access 3 W ay
Calling service. The system will dial out a long Flash to
put the initial call on hold and obtain a new dial tone to
m ake a second call.
Key in the phone number of the second party. After the
private conversation with the second caller, press [3W AY]
softkey to add the first caller into the conference call.
Note: W hen the handset is engaged in 3-way conference call, press the
LINE
key of
the in-use line on the base unit to join the conference call. W hen the 3-way
conference call is initiated from the base unit, pressing the handset
LINE
key of the
in-use line can also join the 3-way conference call.
L1 ON
HOLD
SERVICE DIR. DI
AL V.M
CONFERENCE
LINE1 0 1
.
L1 ON
HOLD
SERVICE DIR. DI
AL V.M.
L1 ON
3456812
00:30
HOLD
3W AY
SERVICE
AD VAN C E D OP E R AT ION
Summary of Contents for SBC373
Page 58: ...57 NOT E...
