Lower
Raise
1. Never place finger
s, toes or
other
body parts under t
he mobi
le base.
2. Always use the saw and the mobile
base on a level surface.
3. Do not c
ontin
ue to
step o
n th
e foot
pedal once the u
pper limit is reached.
4. Lower t
he saw b
efor
e use
. Never
use
the saw when
it is rai
sed off the floor
.
!
WARNING
Never place fingers,
toes or other body parts
under the mobile base.
!
WARN
ING
Never place fingers,
toes or other body parts
under the mobile base.
!
WARN
ING
The SawStop Industrial Mobile Base is designed to fit the SawStop Industrial Cabinet Saw; however this mobile
base conversion kit allows the Industrial Mobile Base to be used with the SawStop Professional Cabinet Saw.
In order to convert the mobile base for use with the SawStop Professional Cabinet Saw, first locate all of the
conversion kit components shown on page
1. All of the hardware needed to convert the
mobile base is located in the hardware bag. If
you are missing the hardware bag or any of the
other components, call the SawStop Service
Department at 503-582-9934 for replacements.
1. Remove the original linkage bar on the
left side of the mobile base by unscrewing
the two M8 shoulder screws with a 5 mm
hex key (see Fig. 1). The shoulder screws
may be difficult to remove because they
were installed with a thread adhesive.
The original linkage bar and the two M8
shoulder screws may be discarded.
SawStop Mobile Base Conversion Kit 2
Assembling Your Mobile Base
Fig. 2
Fig. 1
Fig. 3
2. Repeat the previous step to remove the
original linkage bar on the right side of the
mobile base (see Fig. 2).
3. You must now move the rear support
strap forward to accommodate the smaller
cabinet of the Professional Cabinet Saw.
Begin by removing the two M8 shoulder
screws that mount the rear support
assembly to the mobile base frame with
a 5 mm hex key, as shown in Fig. 3. The
rear support assembly will be used in the
following step, but you may discard the
two M8 shoulder screws.
remove the original
linkage bar on the right
side of the mobile base
remove the two M8 shoulder
screws that mount the rear
support assembly to the
mobile base frame
rear support
assembly
rear face of mobile
base frame
rear support
strap
remove the original linkage
bar on the left side of the
mobile base