Raise
1. N
ever place fingers, toes or other
body parts under the mobile base.
2. Always use the saw and the mobile
base on a
level surface.
3. Do not
conti
nue to ste
p on the foot
pedal onc
e the upper limit is reached.
4. Lower the saw before use. Never use
the saw when it is raised off the floor
.
!
WARN
ING
Lower
Never p
lace fin
gers,
toes o
r other b
ody parts
under th
e mo
bile b
ase.
!
WARN
ING
Nev
er pla
ce finge
rs,
toe
s or
othe
r body
pa
rts
unde
r the
mobile
ba
se.
!
WA
RNIN
G
Never place fingers,
toes or other body parts
under the mobile base.
!
WARN
ING
Never place fingers,
toes or other body parts
under the mobile base.
!
WARN
ING
SawStop Mobile Base Conversion Kit 4
6. The conversion kit includes hold-down brackets to hold the saw in the mobile base. These hold-down brackets
may already be installed on your mobile base. Refer to Fig. 7a and Fig. 7b for the location for each hold-down
bracket. If these hold-down brackets are already installed, skip to step 8. If they are not already installed, you
must now attach them. Begin by removing the two M8 shoulder screws that mount the left side of the front and
rear support straps to the frame with a 5 mm hex key, as shown in Fig. 6. The shoulder screws may be difficult
to remove because they were installed with a thread adhesive. The two M8 shoulder screws may be discarded.
7. Locate the two hold-down brackets and the two M8 x 18 shoulder socket screws. Use one of the M8 x 18
shoulder socket screws to install one of the hold-down brackets to the inside of the rear support strap (see
Fig. 7a). Note that the shoulder screw can only pass through the larger hole in the hold-down bracket and the
hold-down bracket must be oriented so that it bends inward toward the center of the mobile base (see Fig. 7a).
Use the remaining M8 x 18 shoulder socket screw to install the other hold-down bracket to the inside of the
front support strap (see Fig. 7b). Fully tighten both screws using a 5 mm hex key.
Assembling Your Mobile Base
Fig. 6
remove the two M8
shoulder screws that
mount the left side
of the front and rear
support straps
front support
strap
rear support
strap
Fig. 7a
Fig. 7b
M8 x 18 shoulder
socket screw
M8 x 18 shoulder
socket screw
install a hold-down bracket
to the inside of the rear
saw strap as shown
install a hold-down bracket
to the inside of the front
support strap as shown
