8
V1504 Owner’s Manual
Part No. 000692, 30-m06-2017
3. OPERATION
Attendant Operation
•
The attendant shall only operate the lift from the call station located at
the lower landing if the lift is unenclosed.
•
The attendant shall have full view of the floor area under the lift and of
the rider at all times.
•
If the lift is enclosed, the lift can be operated from the upper landing
provided the operator has view of the rider at all times.
•
During attendant operation, the car directional controls must not be
operational.
Operating from the COP Controls
Figure 2 shows a sample car operating panel (COP) for a four-landing
installation.
Figure 2
To operate the V1504 from the COP controls:
1
Insert the key into the switch (if equipped) and turn it to the ON position to
activate the operating buttons.
2
Press the appropriate landing button to move the lift to the destination.
Note that the V1504 will not move if one of the doors is open.
3
When the lift reaches the landing, the door will unlock automatically (for
units with mechanical GAL locks). For units with an electric strike, the door
will unlock automatically for a few seconds when the lift reaches the
landing. If you need to re-open the door after the delay, turn the key (if
applicable) to the ON position and press the call button again to unlock the
door.
4
To prevent unauthorized use of the lift, take the key out when the unit is not
in operation.
Emergency stop
Alarm button
Key switch
Landing buttons
Summary of Contents for V1504
Page 19: ......
