REM-2000-00 Pro Remote – Multi Room
Copyright © 2017 Savant Systems, LLC
009-1536-00 | 171128
7
of
18
5
Installation
5.1
Install Remote
1.
Place the remote and charging base on a surface that is flat, dry, well ventilated, and out of direct sunlight.
2.
Plug the supplied power adapter into a 120 – 240V AC 50/60Hz surge protected outlet receptacle.
3.
Plug the supplied power cord between the remote base and the power adapter from step 3 above.
4.
Place remote into the charging base. Placing the remote onto the base turns on the remote and after a few seconds, the Savant logo will appear.
Allow the remote to start-up into the Connect to Wi-Fi network window shown in step 1 below.
HELPFUL!
If the remote doesn’t automatically power up from step 3 above, press and release the power button on the top of the remote. After
about 5 seconds, the Savant logo will appear.
5.2
Add Remote to a Savant Pro System
Follow the steps below to connect to the local Wi-Fi network and then to a Savant Pro System.
1.
Select the
BEGIN
button.
2.
In the screen that opens, select your local Wi-Fi network.
3.
Enter the PASSWORD for the
network selected.
4.
Select
NEXT
when complete.
•
Reset Wi-Fi Configuration
–
Select to clear any Wi-Fi
credentials currently stored
on the remote and reset the
Wi-Fi radio.
•
Select hidden Wi-Fi Button
–
Select to manually enter a
network name (SSID) and
password. In the screen that
opens, enter the network
name (SSID) of the local
network and follow the
prompts.
•
Retry Scan Button
–Select the
Retry Scan button if the local
wireless network is not initially
listed. A rescan will typically
locate the network.
TIP!
The Level field presented in this screen is the RSSI
value. Higher RSSI values indicates has a stronger Wi-Fi
signal.
Example:
A network with an RSSI of -58 is stronger than
a network with an RSSI value of -77
